Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
a. Precision Plumbing Products.
b. Sioux Chief Manufacturing Company, Inc.
c. Smith, Jay R. Mfg. Co.; Division of Smith Industries, Inc.
d. Watts; a division of Watts Water Technologies, Inc.; Watts Regulator
Company.
3. Standard: ASSE 1018.
4. Pressure Rating: 125 psig minimum.
5. Body: Bronze.
6. Inlet and Outlet Connections: NPS 1/2 (DN 15) threaded, union, or solder joint.
7. Gravity Drain Outlet Connection: NPS 1/2 (DN 15) threaded or solder joint.
8. Finish: Chrome plated, or rough bronze for units used with pipe or tube that is not
chrome finished.
PART 3 EXECUTION
3.01 INSTALLATION
A. Install in accordance with manufacturer's printed instructions.
B. Install in strict conformance with all applicable codes.
C. Install approved potable water protection devices on plumbing lines where contamination of
domestic water may occur: janitor rooms, fire sprinkler systems, premise isolation, irrigation
systems, flush valves, interior and exterior hose bibs.
D. Pipe relief from backflow preventers to nearest drain.
E. Install air chambers on hot and cold water supply piping to each fixture or group of fixtures (each
washroom). Fabricate same size as supply pipe or ¾” minimum, and 18 inches long.
END OF SECTION
PLUMBING SPECIALITIES 15146 - Page 3 of 3