Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
PART 3 EXECUTION
3.01 EXAMINATION
A. Verify that surfaces to receive flashing are thoroughly dry, free from dirt, oil, grease and other
materials, reasonably smooth and without any sharp edges, fins, loose or foreign materials that
may damage membrane.
1. Do not use open flame sources or any other means to expedite drying of adhesives, sealants
or primers.
B. Roughened surfaces that could cause damage shall be properly isolated from the membrane.
C. Verify that locations to receive flashing are sloped so water that enters will drain to building exterior
face.
3.02 PREPARATION
A. Properly fill voids of sheet flashing substrate surface greater than ¼ inch wide with appropriate
material such as mortar or grout.
B. Remove any moisture on the substrate prior to installation.
3.03 INSTALLATION
A. Coordination: Interface flashing work with adjacent and adjoining work to ensure weather
resistance and durability of completed flashing.
B. Install sheet flashing in accordance with manufacturer’s written instructions and details.
C. Upon completion of the masonry veneer installation, trim the sheet flashing as indicated on the
Drawings to form a drip edge. Do not terminate sheet flashing within the mortar joint.
END OF SECTION
EPDM SHEET FLASHING 07650 - Page 2 of 2