Specs

Bridgestone Retail Operations, LLC
PROJECT MANUAL
Version: January 2012
SECTION 07310
ASPHALT SHINGLE ROOFING
PART I
GENERAL
1.01 SECTION INCLUDES
A. The roof system shall consist of asphalt shingles for sloping roofs.
1.02 QUALITY ASSURANCE
A. Materials and methods shall be in accordance with the printed instructions and specifications of the
Roofing Manufacture and the National Roofing Contractors Association (NRCA) Recommendations.
B. The roofing installer shall be certified by the Roofing Manufacturer and have a minimum 3 years
Installation experience and provide evidence of same upon request.
C. The Roofing Contractor shall arrange with a field representative of the Roofing Manufacture and
Owner for a pre-construction meeting prior to the start of Roof Work. This meeting shall be for the
purpose of reviewing the manufacturer’s requirements, specifications, details, materials and methods
of installation for Roof Work.
1.03 SUBMITTALS:
A. Submit the following:
1. Manufacturer’s Literature: Materials description and installation instructions for roofing materials.
2. Roofing Contractor’s Guarantee: Three (3) signed copies.
3. Samples: Pieces of sheet metal flashing.
4. Shop Drawings: Submit two (2) sets of prints to owner for approval of all fabricated items prior to
fabrication. The Contractor will be responsible for all details, dimensions and the correct fit of all
work. Do not fabricate work until owner has approved the drawings.
1.04 DELIVERY, STORAGE AND HANDLING:
A. Deliver materials in manufacturer’s unopened containers identified to show name, brand, type, grade,
and UL label. Store, protect and keep materials dry until roofing is completely installed. Store roll
goods on end.
1.05 PROJECT/SITE CONDITIONS:
A. Protect the building from damage resulting from spillage, dripping and dropping of materials. Repair
and restore other work damaged during roofing operations.
PART 2 PRODUCTS
2.01 MANUFACTURER:
A. Owens Corning or approved equal.
2.02 MATERIALS:
A. Asphalt Shingles: Fiberglass-based asphalt shingles with Tru-Bond nailing strip and SureNail
technology.
1. Wind Resistance: 110 MPH or 130 MPH, to comply with local standards.
2. Fire-Test-Response Classification: UL 790, Class A Fire Resistance.
3. Colors, Blends and Patterns: See drawings. Provide Owner selection from manufacturer’s full
range of colors, textures and patterns for asphalt shingles of type indicated.
B. Ridge Shingles: Manufacturer’s standard, factory-precut units to match asphalt shingles.
C. Ridge Vent: Manufacturer’s standard, factory units to match asphalt shingles
D. Sheet Metal Materials: Coil-Coated Galvanized Steel Sheet: Zinc-coated, commercial-quality steel
sheet conforming to ASTM A 755, G 90 coating designation, coil coated with high-performance
fluoropolymer coating not less than 0.0336 inch thick, unless otherwise indicated.
ASPHALT SHINGLE ROOFING 07310 - Page 1 of 3