Safety Integrated - Industry - Siemens

Ex. No.
2
Settings of the failsafe F-DI
The settings are displayed after double-clicking "4/8 F-DI
DC24V" (see "Overview picture").
DIL switch settings
This value has to be set on the module (F-DI).
F monitoring time
It has to be observed that the F monitoring time must be
larger than the call time of OB 35.
Also in the "Parameter" tab.
The safety position switch is assigned to channel 0, the hinge
switch to channel 4 and the simulation of the speed or standstill
monitor to channel 1. All three sensors are connected as
single-channel. The other channels are deactivated.
186 Functional Example No. AS-FE-I-002-V10-EN
Settings of the failsafe F-DO
The settings are displayed after double-clicking "4 F-DO
DC24V/2A" (see "Overview picture").
DIL switch settings
This value has to be set on the module (F-DI).
F monitoring time
It has to be observed that the F monitoring time must be
larger than the call time of OB 35.
Activate used channels, deactivate channels which are not
used. The read-back time defines the duration of the switchoff
procedure for the respective channel. If the respective
channel switches high capacity loads, the read back time
should be set sufficiently large. We recommend setting the
read back time as small as possible, however large enough so
that the output channel does not become passive.