Safety Integrated - Industry - Siemens

Overview of inputs and outputs
Overview of connected push buttons:
No. HW component (type) Address Symbolic address Default Function
1 Push button (NO) E 0.0 START_ACTUATOR "0" This button switches on the
ACTUATOR indicator light .
2 Push button (NO) E 0.1 ACK_ESTP_ACTUATOR "0" This button acknowledges the
emergency stop circuit.
3 Push button(NO E 0.2 ACK_PASS_ACTUATOR "0" This button acknowledges the
manual reintegration of the
ACTUATOR indicator light.
4 Emergency stop push button
at F-DI (NC/NC)
Overview of connected indicator light:
E 1.0 ESTP_ACTUATOR "1" This button switches off the
ACTUATOR indicator light .
No. HW component (color) Address Symbolic address After startup Meaning
5 Indicator light
(white)
6 Indicator light
(white)
7 Indicator light
(green)
8 Indicator light at F DO
(yellow)
9 Indicator light at F DO
(yellow)
A 0.0 REQ_ACK_ESTP_ACTUATOR "1" The switched on indicator light
indicates, that the emergency
stop circuit requires acknowledgement.
A 0.1 REQ_ACK_PASS_ACTUATOR "0" The switched on indicator light
indicates, that acknowledgement
for manual reintegration
of the ACTUATOR indicator
light is necessary.
A 0.2 PASSIVATION_ON "0" The switched on indicator light
indicates the current passivation.
A 7.0 ACTUATOR "0" The indicator light simulates
the "hazardous loads".
The switched on indicator light
indicates the "hazardous
loads" being switched on
A 7.1 TEST "1" The indicator light is only used
to demonstrate the passivation
of the entire module. The
indicator light has no other
function.
Normally, TEST is always
switched on. TEST is only
switched off if F-DI is passivated.
Functional Example No. AS-FE-I-011-V10-EN 321
Ex. No.
11