Safety Integrated - Industry - Siemens

Ex. No.
11 Wiring of hardware components
This chapter contains information on the setup of hardware
components. It contains the required address settings and the
wiring plan.
Address settings
The following addresses must be set at the DIL-switches of the
hardware components.
Hardware component
IM 151
HIGHFEATURE
Address to be
set at the DIL
switch
3 (PROFIBUS address)
4/8 F-DI 0011001000
(PROFIsafe address)
4 F-DO 0011000111
(PROFIsafe address)
Note
You can change the
PROFIBUS address.
The PROFIsafe addresses are
automatically assigned when
configuring the fail-safe
modules in STEP 7.
Please ensure that the setting
at the address switch of the
F-I/O-module (DIP switch) on
the module side corresponds
to the PROFIsafe address in
the hardware configuration
of STEP7.
320 Functional Example No. AS-FE-I-011-V10-EN
Wiring plan
Please wire the hardware components according to the wiring
plan (following figure).
Please include the following additional wiring settings:
■ Power supply "PS 307" with 230V AC
■ Connect the DP interface of the CPU 315F-2 DP with the
DP interface of the IM 151 HF.