Safety Integrated - Industry - Siemens

Ex. No.
3
Important hardware component settings
Below, several important settings from the hardware configuration
of STEP 7 are shown to provide you with an overview.
These settings are available in the included STEP 7 project. It
is basically possible to change these settings (e.g. due to individual
requirements), but please consider the following note:
Warning!
The settings shown below contribute to meet the requirements
of Safety Category 4. Changes at the settings
may cause loss of safety functions.
If you implement changes (e.g. add an additional module),
the sample code has to be adapted accordingly.
198 Functional Example No. AS-FE-I-003-V10-EN
Overview picture
The PROFIBUS adress at IM 151HF is set using DIP-switches.