Safety Integrated - Industry - Siemens

Ex. No.
8 Wiring of the hardware components
Requirements: The power supplies are supplied with 230V AC.
First check the addresses set at the hardware components
listed below:
Hardware
component
IM 151 High
Feature
Einzustellende
Address
6 (PROFIBUS address)
F-DI Switch position:
1111111110
F-DO Switch position:
1111111101
Note
Can be changed
The PROFIsafe addresses are
automatically assigned during
configuring the fail-safe
modules in STEP 7. The
PROFIsafe addresses 1 to
1022 are permissible. Please
make sure that the setting at
the address switch (DIL
switch) on the side of the
module corresponds to the
PROFIsafe address in the
hardware configuration of
STEP 7.
IM 151
HF
PM-E
2DI
HF
2DO
HF
F-DI
PM-E F-DO
Note
In this example we used a motor holding brake (see following
page). The parameters for the MICROMASTER
used by us, take this motor holding brake into consideration.
If you do not want to use the motor holding break,
the contactor K3 is not necessary.
266 Functional Example No. AS-FE-I-008-V11-EN
A4
Note
The DP interface of the CPU 315F must be connected
with the DP interface of the IM 151 HF.
Note
The wiring of the hardware is illustrated below. In the
following table, the hardware components occurring
several times are numbered so they can be allocated in
the subsequent wiring plan.
IM 151
HF
2 DI HF
1 5
2 6
3 7
A8
PM-E
2 DI HF
A4
1 5
2 6
3 7
A8
2DI
HF
2DO
HF
F-DI
PM-E F-DO
2 DI HF
1 5
A4
2 6
3 7
A8
G_FB_XX_156
AUX1
4 8
A4
PM-E PM-E
2 6
3 7
A8
AUX1
4 8
A4
2 6
3 7
A8
G_FB_XX_155