Safety Integrated - Industry - Siemens

Inputs and outputs used for the DP Master CPU
(CPU412-2)
No. HW component Address Symbol Signal (default
value)
Note
Nr. Push button (NO) E 0.0 START "0 Start request
1 Push button (NO) E 0.1 ACK "0 Acknowledgement
2 Push button (NO) E 0.2 STOP "1 Operational stop
3 Push button (NO) E 0.0 START "0 Start request
No. SW component Address Symbol Signal (default
value)
Note
4 Software output Output
DB2.DBX
3.0
OUT1 "0 Bit in control word for MASTERDRIVES (for 1: drive starts).
Inputs and outputs used for the DP Slave CPU
(IM 151-7F-CP)
No. HW component Address Symbol Signal (default
value)
Note
1 Push button (NC/NC) E 0.0 ESTP "1 Emergency-stop button
2 Push button (NC/NC) E 0.1 SIM_FDOR "1 Position switch
3 Push button (NC/NC) E 0.2 DMS "0 Dead Man Switch. Must remain pressed permanently in "safe
speed" (SG) mode.
4 Switch engages E 0.3 REQ_SG "0“ Mode switch
0: Normal operation
1: "safe speed" (SG)
No. SW component Address Symbol Signal (default
value)
Note
5 F-DO A 6.0 OUT3 "0“ Connection from F-DO (via K1) to MASTERDRIVES. At signal
change from 1->0 fast stop (immediate stop of the drive) is triggered.
6 F-DO A 6.1 K2 "0“ Contactor (tested without connected load circuit).
7 F-DO A 6.2 K80 "0“ Contactor for switching the safety relay of the K80 option of
MASTERDRIVES.
Testing inputs and outputs
Prerequisite: The inputs and outputs have the default values
specified under "Inputs/outputs used".
Functional Example No. AS-FE-I-012-V10-EN 375
Ex. No.
12