Safety Integrated - Industry - Siemens

Function test
After wiring the hardware components, you can check the inputs
and outputs used with regard to their functionality (after
downloading the S7 project).
Inputs/outputs used
No. Hardware
component
Testing inputs and outputs
Requirements: The inputs and outputs have the default values
specified under "Inputs/outputs used".
Adress Symbol Signal
(default value)
1 Push button (NO) E 0.0 START "0" –
2 Push button (NC) E 0.1 STOP "1" –
3 Position switch E 2.0 SW1 "1" "1" signal, if actuator in the position
switch
4 Push button (NO) E 2.1 ACK "0" Acknowledgement
5 Position switch E 2.4 SW2 "1" "1" signal, if actuator in the position
switch
6 Indicator light (yellow) A 8.0 ACTUATOR "0" Simulates "machine"
No. Instruction A 8.0 Note
1 Pull both actuators
from the
position
switches
2 Plug both actuators
into the
position
switch.
3 Press the push
button E2.1
and release it
4 Press the push
button E0.0
and release it
5 Press the push
button E0.1
and release it
6 Press the push
button E0.0
and release it
7 Pull one actuator
from the position
switch
"0" Open the safety
door
"0" Close safety door
"0" Acknowledge
"1" "Machine" start
"0" "Machine" stop
"1" "Machine" start
Necessary prior
to the first
start.
"0" Error case: Door open, an actuator
breaks and gets stuck in the position
switch
Note
No. Instruction A 8.0 Note
8 Plug the actuator
back into
the position
switch
"0" Close safety door
9 Press the push "0" Acknowledgement obligatory after
button E2.1
and release it
opening the safety door
10 Press the push
button E0.0
and release it
"0" Start not possible, only...
11 Repeat no. 1 to "1" ... after completely opening and
4
closing the safety door and subsequent
acknowledgement.
12 Press the push
button E0.1
and release it
"0" "Machine" stop
Functional Example No. AS-FE-I-004-V10-EN 211
Ex. No.
4