Practical Guige to Free Energy Devices

addition, not required to radiate wasted energy with a cooling fan.
The correct method in testing a switched reluctance motor is to integrate E x Iav with the machine switching
frequency using standard measuring instruments, the result of which is often ironically very close, if not identical,
with results of the calorimetric tests, and this is obtained using the equation first outlined in the Adams Motor
Manual, i.e., Iav x E x Duty Cycle, corroborated by the New Zealand Electricity Department 1976 and Lucas
Electrical Industries, Research Division, United Kingdom 1976.
If you construct an Adams Motor which appears to be running well and is operating under load without getting hot,
i.e., around the order of 20 - 15 degrees or less above ambient of 20 degrees, then it will, if calculations are
carried out correctly, be operating beyond unity.
Calorimetric testing analyses, as outlined in this Addendum, is an expensive, time-consuming exercise, is
complex to calculate and requires considerable experience and skill. This procedure is not recommended to those
who are not very, very well prepared with the above prerequisites.
NEW SCIENCE
THE ADAMS SUPER-POWER MULTI-POLAR MAGNET
I have for many years, theorised the existence of four poles interacting in any magnet. There is little doubt that two
poles dominate from what is observed, and taught, in classical texts.
However, since my discovery of engineering magnets into forming four poles - and, in so doing, quadrupling the
energy - surely some light has been shed on the theory of the existence of four poles. Bruce Cathie and I will
investigate this further when time permits.
A rectangular or cube magnet, when engineered into the Adams technology, becomes a unit consisting of four
twin poles, each face containing a north and a south pole, separated by a zero vortex in the centre of each of the
four twin poles, and all displaying similar energies.
Ironically, but not unexpectedly, this super twin-pole magnet is a very valuable adjunct to further advancement of
the Adams Motor technology. The energy found on the edges of each of the four faces is very high-25 per cent of
the total energy of the full face.
The present lab magnets are approximately three-quarters-of-an-inch cube. The edge of any face will hold a fivekilogram
steel or iron block in mid-air. When the full face of the magnet is attached to metal, a force of beyond 20
kg is required to remove it. In my presentation to the NEXUS Conference, I advised tests would be carried out this
month to determine the load required to remove the magnet.
The dice-sized magnet was attached to a steel plate on a ceiling rafter and, with the aid of a chain, a 15-kilogram
block was first attached to it; then a 4.7-kg block added on with a nylon rope; then another 200-gram block was
attached; then, a fourth 200-gram block. The magnet still hanging fast, a 100-gram block was added; then...wait
for it...CRASH to the floor. The magnet was still attached to its anchor on the roof-rafter!
A magnet, approximately three-quarters-of-an-inch cube, weighing only 60 grams. capable of holding a weight of
beyond 20 kilograms in mid-air. 333.333 times its own weight? Will this at last have something of an effect on the
closed ignorant minds of conventional science?
The way now must surely be clear that space/gravity energy via electromagnetic forces of permanent magnets is
not impossible nor difficult to harness. The space/gravity energies are clean, non-exhaustible and free. The
Adams technology has proved this and leaves no grounds for dispute.
Einstein's sacrosanct theories of relativity, and the laws of thermodynamics, are the most remarkable and
inexplicable aberrations ever recorded in scientific history. These draconian false teachings have been
instrumental in impeding the process of science towards free, clean energy.
CLASSICAL THEORY AND ADAMS TECHNOLOGY
The classical theory of magnetism from the textbooks attributes the phenomenon to the motion of electrons within
the atoms of molecules. There is evidence that the orbital electrons in an atom not only revolve about the nucleus
of the atom, but also each individual electron spins about an axis through its centre. It is believed that in highly
2 - 9