Practical Guige to Free Energy Devices

Energy stored, multiplied by the cycles per second, is the energy being pumped by the system. Capacitors and
inductors (coils) temporarily store electrons.
Capacitor formula: W = 0.5 x C x V 2 x Hz where:
W is the energy in Joules (Joules = Volts x Amps x seconds)
C is the capacitance in Farads
V is the voltage
Hz is the cycles per second
Inductor formula: W = 0.5 x L x A 2 x Hz where:
W is the energy in Joules
L is the inductance in Henrys
A is the current in amps
Hz is the frequency in cycles per second
Both one Henry and one Farad equal one volt. The higher the frequency, including the squaring of the flux lines,
causes a large increase in the amount of energy being produced. This, combined with the use of a resonant
energy induction system (all electrons moving in the same direction at the same time), make the move into
COP>1 practical.
The damping process of conventional electrical power generation, has all of the available electrons bouncing
randomly, mostly cancelling out each other, and so the useful energy available is only a very small percentage of
the energy which is present. In a resonant induction system, a very high percentage of the energy present is
useful. When resonating, (ohms-impedance-Z) becomes zero and all of the energy present becomes available,
without being degraded in any way. Ohms is load or wasted energy and amperes is the rate of that wasting.
Now, apply this information to an air-core coil resonant transformer energy system. L-1 and L-2 coils are now
present. L-1 has fewer turns and is several times the diameter of L-2. Input from a 12-volt 'gelcel' high-voltage
laser module, produces 8,000 volts with low (wasted energy) amperage into 4 turns of coil L-1. Each turn of L-1
then acquires 2,000 volts of resonant potential. Each turn of L-2 is then exposed to an electric flux of 2,000 volts.
Each turn at the bottom end of L-2 acquires 2,000 volts. The flux lines are squared and are additive as the
voltage and amperage progress towards the top end of L-2's many turns.
A huge number of flux lines which were not previously present, occur at the top end of L-2. These flux lines excite
the electrons nearby in it's earth and air and groundings. This high level of excitement above the ambient, causes
a large number of electrons to become available, electrons which previously, were not part of the energy present.
At this point, large amounts of excess energy is present. This COP>1 device produces energy at radio
frequencies in the megahertz range and this allows it to be small in size and yet produce large amounts of energy.
A megawatt sized unit will sit comfortably on a breakfast table. The energy is changed to direct current, and then,
to the desired working frequency.
The energy powering these devices is drawn from the surrounding energy field and is not conventional electricity
and it does not flow through the wire of the ‘secondary’ coil, but instead, it runs along the outside of the coil and
through space to strike the surface of the metal plate, where it generates conventional electric current. Thomas
Henry Moray demonstrated that this energy flowing along the outside of the wire can pass through glass without
being affected in any way.
In his 1995 paper Don Smith presents the following diagram:
5 - 83