Practical Guige to Free Energy Devices

generators which use the transformation of torque into electricity, whereby however, the energy value of the input
torque is greater than the energy value of the electricity this generated.
It was found that from each pole of the permanent magnet to the two ends of a U-shaped generator core one of
the magnetic flux modification or guidance coils with or without core for transmission of the magnetic induction flux
has to be designated in such a manner that by alternating induction flux, which is caused by the permanent
magnet e.g. in the rhythm of the phase change of an alternating current frequency of the energising current the
generator core is constantly commutated, as the North-pole will be transferred alternating to one and the other
open end of the core and the coils likewise leading to the core to s-pole of the permanent magnet close the
reversible magnetic circuit in the core with each current pulse, which is caused by a permanent magnet.
In this way the induction flux in the core experiences its desired flux direction change and produces in the output
windings of the generator an Alternating Current of the same frequency as those of the energising current,
however with identical frequency to that of the input energising current.
Since the pulsating or reversible induction flux is caused by a permanent magnet, no electric current is necessary
for its production also for the whole length of the generator core and its output windings, because the reversible
magnetic excitation of the core takes place indirectly in each case or directly via a permanent magnet, whose
remanence is changed by the magnetic excitation of the generator core in accordance with the invention.
The system according to invention for energy production and energy producer can be extremely efficient e.g. in
high frequency operation with electronically controlled direct current pulse operation and it can output a multiple of
the necessary input current and electricity be produced in this way, is produced without material being used up
and without a thermal circuit or a torque being necessary.
If several of these generators are cascaded in graduated increasing size e.g. in a series where the second
generator receives the full output from first and third generator receives the full output of the second, then with a
power multiplier of 10 for each generator, the sixth generator in the chain will have a 1000 MW performance if
there is a 1000 W power input to the first (and smallest) generator at the start of the series.
Thus it is possible to replace all well-known primary energies and procedures of the energy conversion with the
systems and energy generators according to invention, for all future on economical into electricity because of their
high costs, since these cannot operate in any way remotely as economically, as it is possible
with the devices of this invention.
Valeri Ivanov’s Motionless Generator.
There are other devices which have what appears to be a very important air-gap in a
magnetic frame. One of these was displayed on a Bulgarian website and is on the web page
which is located at http://www.inkomp-delta.com/page3.html, put up by Valeri Ivanov in 2007.
Valeri lives in Elin Pelin, Bulgaria and his motionless generator has COP=2.4 performance.
Videos:
http://www.youtube.com/watch?v=7IP-buFHKKU and
http://www.youtube.com/watch?v=npFVaeSbk1Q are for his design, and it appears that he is about to go
commercial: http://www.inkomp-delta.com/index.html in May 2014.
It is shown that an effective device can be constructed from a permanent magnet, a toroid and a laminated iron
yoke. The arrangement is displayed like this:
3 - 81