Practical Guige to Free Energy Devices

If this interruption of the flux flowing from the permanent magnet is large, and has the waveform of a Alternating
Current, then a pulsating Direct Current is induced in the coil wound around the core.
With an AC input to the magnetic flux modifier coil wound on the core beside the magnet, the coil receives two
current flow direction changes per AC cycle, and so the magnetic flux coming from the permanent magnet is
interrupted once and released once during each input power cycle. In this way, a pulsating induced Direct
Current is generated in the output coil caused by the pulsating magnetic flux in the core.
It was found that the induced flux from a permanent magnet achieves its full initial value of the magnetic flux
density in the core also at the free end of the soft-iron magnetic core, even if there are several induction windings
each with the same number of turns and the conductor cross section are appropriate as in a magnetic flux
modification coil wound on the core, without changing the strength of the magnetic flux density or the remanence
of the permanent magnet.
The permanent magnet is not demagnetised when used to provide the flux in the core, no energy is extracted
from it, unlike an electromagnetic core, whose windings require more operating current than that produced as an
output. With an electromagnetic core, as much input current is required, as is induced in the output winding,
corresponding to the relationships of the well-known transformer. Therefore it is important to produce the
induction flux by using a permanent magnet.
After the basic primary system, one can build e.g. energy linear generators or energy circle generators or other
arising or suitable types and forms of energy generators, without the necessity of a rotor or a stator or any such
mobile sections or providing torque in the generator.
The invention is so designed as to make only frequency control governed by electrical means so that the internal
induction flux in the generator core is essentially caused by the magnetic field of the permanent magnet.
In the drawings constructional examples are schematically represented according to the invention:
Fig.1 shows a linear energy generator in longitudinal cross-section.
Fig.2 shows a linear energy generator in the instantaneous state of the transmission of the induction flux of the
permanent magnet to the generator core and
Fig.3 represents a linear energy generator at the moment of the interruption by the induced flux;
3 - 75