09.02.2018 Views

Practical Guige to Free Energy Devices

eBook 3000 pages! author: Patrick J. Kelly "This eBook contains most of what I have learned about this subject after researching it for a number of years. I am not trying to sell you anything, nor am I trying to convince you of anything. When I started looking into this subject, there was very little useful information and any that was around was buried deep in incomprehensible patents and documents. My purpose here is to make it easier for you to locate and understand some of the relevant material now available. What you believe is up to yourself and is none of my business. Let me stress that almost all of the devices discussed in the following pages, are devices which I have not personally built and tested. It would take several lifetimes to do that and it would not be in any way a practical option. Consequently, although I believe everything said is fully accurate and correct, you should treat everything as being “hearsay” or opinion. Some time ago, it was commonly believed that the world was flat and rested on the backs of four elephants and that when earthquakes shook the ground, it was the elephants getting restless. If you want to believe that, you are fully at liberty to do so, however, you can count me out as I don’t believe that. " THE MATERIAL PRESENTED IS FOR INFORMATION PURPOSES ONLY. SHOULD YOU DECIDE TO PERFORM EXPERIMENTS OR CONSTRUCT ANY DEVICE, YOU DO SO WHOLLY ON YOUR OWN RESPONSIBILITY -- NEITHER THE COMPANY HOSTING THIS WEB SITE, NOR THE SITE DESIGNER ARE IN ANY WAY RESPONSIBLE FOR YOUR ACTIONS OR ANY RESULTING LOSS OR DAMAGE OF ANY DESCRIPTION, SHOULD ANY OCCUR AS A RESULT OF WHAT YOU DO. ​

eBook 3000 pages!
author: Patrick J. Kelly

"This eBook contains most of what I have learned about this subject after researching it for a number of years. I am not trying to sell you anything, nor am I trying to convince you of anything. When I started looking into this subject, there was very little useful information and any that was around was buried deep in incomprehensible patents and documents. My purpose here is to make it easier for you to locate and understand some of the relevant material now available. What you believe is up to yourself and is none of my business. Let me stress that almost all of the devices discussed in the following pages, are devices which I have not personally built and tested. It would take several lifetimes to do that and it would not be in any way a practical option. Consequently, although I believe everything said is fully accurate and correct, you should treat everything as being “hearsay” or opinion.

Some time ago, it was commonly believed that the world was flat and rested on the backs of four elephants and that when earthquakes shook the ground, it was the elephants getting restless. If you want to believe that, you are fully at liberty to do so, however, you can count me out as I don’t believe that. "

THE MATERIAL PRESENTED IS FOR INFORMATION PURPOSES ONLY. SHOULD YOU DECIDE TO PERFORM EXPERIMENTS OR CONSTRUCT ANY DEVICE, YOU DO SO WHOLLY ON YOUR OWN RESPONSIBILITY -- NEITHER THE COMPANY HOSTING THIS WEB SITE, NOR THE SITE DESIGNER ARE IN ANY WAY RESPONSIBLE FOR YOUR ACTIONS OR ANY RESULTING LOSS OR DAMAGE OF ANY DESCRIPTION, SHOULD ANY OCCUR AS A RESULT OF WHAT YOU DO.

SHOW MORE
SHOW LESS
  • No tags were found...

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

again on the ascending side of the chain. Immediately after turning around the bot<strong>to</strong>m pulley, each bucket<br />

receives the rising airflow.<br />

Fig.17 shows the arrangement at the <strong>to</strong>p of the water tank 2010. Buckets 2030 rising due <strong>to</strong> being filled with air,<br />

turn over as they pass around the <strong>to</strong>p pulley 2018, releasing the air inside them and start descending again<br />

<strong>to</strong>wards the bot<strong>to</strong>m pulley. The upper axle 2018 has an estimated rotational speed of 120 rpm.<br />

In Fig.17 I (Ribero) am showing the transmission of this energy <strong>to</strong> an axle at the <strong>to</strong>p of the water column where we<br />

have a genera<strong>to</strong>r 2050 requiring a rotation of 300 rpm plus an engine connected <strong>to</strong> another genera<strong>to</strong>r with rotation<br />

of 600 rpm. This part of Fig.17 is only illustrative <strong>to</strong> show that we shall generate energy at the primary axle at 120<br />

rpm, or use any kind of transmission <strong>to</strong> more convenient rotational speeds.<br />

***<br />

I think that the words marked in red indicate that although this patent has been granted, the genera<strong>to</strong>r has never<br />

been built and is only an idea. Personally, I am highly dubious about the mechanisms which are supposed <strong>to</strong> give<br />

reduced water pressure at the air intake, as I don’t think that they would work, or if they do, certainly not for the<br />

reasons stated. What he wants <strong>to</strong> do can certainly be done, but not in the way that he suggests. If the axles are<br />

rotating at the 120 rpm which he suggests, then that would allow less than one eighth of a second <strong>to</strong> fill each<br />

bucket and while the notion of reduced water turbulence through the buckets <strong>to</strong>uching each other is attractive, I<br />

don’t think that the method described is feasible.<br />

So, while we can be sure that buoyancy methods are perfectly capable of generating serious power, we need a<br />

better design than either of the two shown here as the Hidro appears <strong>to</strong> be very expensive <strong>to</strong> build.<br />

The Thirty Kilowatt Mo<strong>to</strong>r<br />

The recent website http://www.rarenergia.com.br/ shows a gravity-powered mo<strong>to</strong>r which is capable of driving a<br />

30-kilowatt electrical genera<strong>to</strong>r.<br />

This is certainly not a home-build project and the cost of construction and day-<strong>to</strong>-day maintenance cost makes<br />

this appear <strong>to</strong> be a very uneconomic project. However, one enormous advantage of the building of these two<br />

genera<strong>to</strong>rs is that they show very clearly that free-energy is available and perfectly viable. The people building<br />

these two constructions point out very clearly that these are gravity-powered mo<strong>to</strong>rs rather than just electrical<br />

genera<strong>to</strong>rs. While these mo<strong>to</strong>rs can drive electrical genera<strong>to</strong>rs, it is emphasised that they can also perform any<br />

task which needs a mo<strong>to</strong>r, such as pumping, drilling, etc. The size of these mo<strong>to</strong>rs is substantial as can be seen<br />

from the following pictures:<br />

4 - 56

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!