Practical Guige to Free Energy Devices

‘UFOpolitics’ comments on these arrangements as follows: As we excite the input of the Motor, the Generator will
start producing energy and that additional energy will flow through the Motor Output side because they are
connected in series here. Two rectifiers must be connected at both output terminals, Positive and Negative, to
avoid back flow from closing the circuit through the load.
As the Motor accelerates, the Generator boosts the energy flow which then runs through the Motor augmenting
the Output Fields and when the output is loaded then an ‘Engagement’ of both Machines occurs as they start to
compensate each other through their output flows. It should be understood that the Output should be Capacitor
Banked in a dedicated Reservoir.
When designing a Generator for a specific, existing Asymmetric Motor machine, it must be understood that
Generator Interactions should be considered to run as “Counter Rotation” to the Motor Machine’s originally
conceived rotation (which is easily done by just moving brush-lines passing stator bisector angles to the opposite
of those needed for a Motor, or alternatively, setting the timing backwards). This will definitively enhance the
assisted rotation of both Machines when connected together in this Face-to-Face mode.
As I do not find the forum comments easy to understand, I recommend that you visit the forum and read the posts
as you may well understand the conversations easier to follow than I do.
On the forum, ‘Sanskara316’ states “I have re-wound a small 3-volt 3-pole motor. I used an almost dead, 6-volt
sealed lead-acid battery to power the motor. This battery just sits at around 4 volts and if given a load, even a
small LED, it’s voltage drops to 1 volt. The re-wound motor started very slowly - barely spinning, then after a
minute or two it started to spin faster, and I noticed that the voltage on the battery was slowly climbing. I
connected a small LED flashlight to the generating side and it lit up. Now the battery voltage under load is around
2+ volts. It’s been running for an hour now and the machine squeals a lot. It is conditioning the battery and the
meter cannot be showing what really is happening. The motor draws 300 ma?? – That’s not possible as the
battery just doesn't have that power”. To which ‘UFOpolitics’ remarks: “Well I am glad you have witnessed some
of the ‘Effects’... these re-wound motors do recondition batteries...remember, Radiant Energy is taking over the
Machine...so Radiant Energy comes out through the Input also… which is the reason why we get high Volts-Amps
reading on a meter ...these motors use very small amounts of current and volts. Inside the motor, every coil is
being ‘Self-Electromagnetically-Pulsed’ because they auto-disconnect from the power source, then the next coil in
the sequence is assisted by the first coil when it has rotated to it’s next position, and so on. The commutator
switching has become a ‘Self-Oscillator’ for every independently-energised coil.”
Another forum member ‘prochiro’ says: “I have also replicated the battery-charging events that ‘Sanskara316’
indicated. I started with a 12-volt 4 Amp-Hour battery which I had been using with another circuit two weeks ago
and had not recharged it after using it for hours. It was sitting at 12.40 volts. I took my best-running re-wound
motor, plugged it in direct and ran it. The battery voltage dropped to 12.24 volts and stayed at that level for 30
seconds. The battery voltage then started to rise 1/100 of a volt per minute. When it was at 12.27 volts, I
2 - 117