Navy Cash Standard Operating Procedures - Financial Management ...

0 CONNECTIVITY ERROR1 CALL MAINTENANCE23This error indicates Serial Port communication cannotbe activated.0 Loading Configurations123The device is loading saved configurations.2.3.7 Device Setup Screensa. Initial Device Configuration Screens: After the K22 is flashed, it needs to beconfigured, and an initial password is required to protect the configuration information. Thepassword must be four digits long. The password is not saved until the Device Setup is saved.Under normal circumstances, all K22s received on the ship have already been set up and apassword has already been assigned, either by the installation team or the depot. To beginconfiguring a K22 for merchant use, skip to step “c” below, press the “5” key to enter the adminmode, enter the current four-digit admin password, press the “3” key to bring up the stateselection screen, and then skip to step “f” below to select either normal mode or proxy mode asappropriate.0 Enter New1 Admin Password23 CLR=Clear OK=Done0 Re-Enter New1 Admin Password23 CLR=Clear OK=DoneAs the password is entered, a series of asterisks isshown on line 2. If CLR is pressed, the digits arecleared, and the user can re-enter. If OK is pressedbefore any digits are entered, line 3 changes to say “Avalue is required”. If OK is pressed before all fourdigits are entered, line 3 changes to say “4 digitsrequired”.If OK is pressed after four digits have been entered,the next screen will ask for the new password to bereentered. If the reentered four digits are not the sameas the original four digits, the K22 will ask for a newpassword to be entered again. The K22 will notcontinue until both passwords are the same.NC SOP Ver 1.12 Chpt 2 K22 K80.doc 2-12 16-Aug-07