Volume-II of IV - GAIL

MECON LIMITED
REGD. OFF : RANCHI (BIHAR)
PROCESS & PIPING
DESIGN SECTION
NEW DELHI
STANDARD SPECIFICATION
TITLE QUALITY ASSURANCE SYSTEMS SPECIFICATION NO. PAGE 5 OF 9
REQUIREMENTS MEC/S/05/62/66 REVISION 0
After award of work, the bidder may review augmentation of manpower and
resources deployment chart (submitted earlier), detail it out, if so consented
by MECON/ Owner and resubmit the same as “issued for effective
implementation of the project”.
4.2 The bidder shall plan the contract scope of work on quality plan format such
that no major variation is expected during delivery of contract scope of work.
These quality plan shall be made on enclosed format complete in all respect.
The quality plan shall be assumed to be detailing bidder’s understanding and
planning for the contract/ offered scope of work. The bidder shall plan the
type of resources including various work methodology which he agrees to
utilize for delivery of contract scope of work.
4.3 The bidder is required to review the contract at all appropriate stages to
evaluate his capabilities with respect to timely and quality completion of all
activities pertaining to contracted scope of work and shall report for
constraints, if any to MECON/ Owner.
4.4 The design activities, if any, performed during delivery of contract scope of
work shall be so controlled that the outputs is reliable enough. It is expected
that during development of design, the bidder shall take recourse to detailed
checking, inter departmental reviews and documented verification methods.
4.5 For all documents which the bidder is likely to utilise for delivery of contract
scope of work, a system must exist which assures that latest/ required
version(s) of the document(s) is available at all location/ point of use.
4.6 In case the bidder decides to sub-contract any part/ full of the contract scope
of work (without prejudice to main Contractual condition), the bidder shall :
• Evaluate the technical and financial capabilities and past performance of
the sub-contractor(s) and their products and/ or services before
awarding them with the sub-contracted scope of work. Selection of a
sub-contractor should meet MECON approval in documented form.
• Requirement of this specification shall be enforced on sub-contracted
agency also. The bidder shall choose sub-contractor based on their
capability to meet requirements of this specification also.
\\Akjha\work contrac\standard TS for Pipe Line WC (Vol-II) MASTER FOLDER\66 quality assurance system\Specification - Quality Assurance Plan - Reqd. - 66.doc