Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

6-42 Mounting and Installation Rexroth IndraDrive
Design
Connection Cross Section
X3, Mains Connection
DANGER
High electrical voltage! Danger to life, severe
bodily harm by electric shock!
Always operate the drive controller with plugged on
⇒
connector!
HCS02.1E- Type Number of
poles
W0012 Screw terminal
block
W0028 Screw terminal
block
W0054 Screw terminal
block
W0070 Screw terminal
block
Fig. 6-43: Design
Type of design
4 Pins on device
4 Pins on device
4 Pins on device
4 Pins on device
HCS03.1E- Type No. of poles Type of design
W0070 Connector 4 Screw connection
W0100 Terminal block 3 Screw connection for
M6 ring cable lugs
W0150 Terminal block 3 Screw connection for
M6 ring cable lugs
W0210 Terminal block 3 Screw connection for
M10 ring cable lug
Fig. 6-44: Design
Identification of the individual connections:
Identification Significance
L1 phase 1
L2 phase 2
L3 phase 3
(PE) equipment grounding conductor
Fig. 6-45: Identification of the individual connections mains connection
Note: Only with single-phase operation: connect the connecting lines
of the mains voltage supply L1 and N with the connections L1
and L2.
HCS02.1E- Cross section
single-wire
[mm²]
Cross section
multi-wire
[mm²]
Cross section
in AWG
W0012, W0028 0,2-4 0,2-4 24-10
W0054, W0070 0,5-10 0,5-10 20-8
Fig. 6-46: Connection cross section
DOK-INDRV*-FU*********-IB01-EN-P