Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

Rexroth IndraDrive Commissioning and Parameterization 7-13
Possibilities of Display of
Comfort Control Panel
Possible Settings with Comfort
Control Panel
Command Activation with
Comfort Control Panel
DOK-INDRV*-FU*********-IB01-EN-P
Comfort Control Panel
Fig. 7-3: Comfort control panel
Note: The comfort control panel
• can be used with control sections CSB01.1N-FC
• requires firmware FWA-INDRV*-MPB-04V12 at least
• only supports voltage controlled operation (V/f control)
• must have been plugged in when the drive controller is
switched on so that it can be recognized
• is suited for hot plug, i.e. you may disconnect it when the
drive controller has been switched on
Compared to the standard control panel, the comfort control panel, due to
the fact that it can be programmed, provides additional settings, as well
as additional display and command functions.
Additional possibilities of display of the comfort control panel (compared
to the standard control panel), for example:
• cyclic parameter display
• measured value of motor temperature sensor
• message threshold or shutdown threshold for motor temperature
• active switching frequency (PWM)
Note: To use this function you need a comfort control panel of
version VCP01.2BWA-TS-NN-FW (see type plate of comfort
control panel).
Additional possibilities of setting of the comfort control panel (compared to
the standard control panel), for example:
• language selection
• set/change single parameters
• input of motor data acc. to type plate data for asynchronous third-party
motors
Activation of further commands with the comfort control panel (compared
to the standard control panel), for example:
• C3200 Command Calculate motor data