Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

Rexroth IndraDrive Mounting and Installation 6-51
Connection Cross Section
Tightening Torque
DOK-INDRV*-FU*********-IB01-EN-P
HCS03.1E- Type No. of
poles
Type of design
W0070 Connector 2 Screw connection
W0100..0210 Screw terminal
block
Fig. 6-66: Design
Identification of the individual connections::
Identification Significance
1 Phase 1
2 Phase 2
Fig. 6-67: Identification of the individual connections
HCS02.1E- Cross section
single-wire
[mm²]
2 Screw connection
Cross section
multi-wire
[mm²]
Cross section
in AWG
W0054, W0070 0,5-10 0,5-10 20-8
Fig. 6-68: Connection cross sections
HCS03.1E- Cross section
in [mm²]
Cross section
in AWG
W0070 16 6
W0100, W0150 25 4
W0210 50 0
Fig. 6-69: Connection cross sections
HCS02.1E- Tightening torque [Nm]
W0054, W0070 1,2 – 1,5
Fig. 6-70: Tightening torque
HCS03.1E- Tightening torque [Nm]
W0070 1,5
W0100, W0150 2
W0210
Fig. 6-71: Tightening torque
8
CAUTION
Damage to the drive controller!
You have to provide strain relief for the connection
⇒
cable in the control cabinet or use the optionally
available connection accessory (shielding plate;
HAS02.1).
Note: With twisted or shielded cable, the maximum cable length for
the braking resistor is 5 m.