Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

Rexroth IndraDrive Commissioning and Parameterization 7-31
Load Basic Parameters
DOK-INDRV*-FU*********-IB01-EN-P
• Press ▼ key.
Name and unit of parameter are displayed.
Parameter Management
• Go to main screen.
By pressing ◄ key several times you get to main screen. By means of
Esc key, you might possibly have to exit editing mode before.
• Press key ►.
Mode selection is displayed.
• Select Parameter management
• Press key ►.
Parameter mode is automatically displayed. Following display appears:
PM: parameter mode
Fig. 7-26: Display "Load basic parameters"
When drive controller was in status AF (drive enable), following display
appears:
Fig. 7-27: Error message when switching operating mode/parameter mode
Switch off drive enable and repeat procedure.
• Select Load basic parameters.
• ► Press key.
Following display appears:
Fig. 7-28: Load basic parameters