Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

7-30 Commissioning and Parameterization Rexroth IndraDrive
• Select Change single parameter
• ► Press key.
The following display appears:
Fig. 7-24: Select parameter
• With keys Prog + , ⎺Mon, Enter, ◄, ►, enter desired parameter (see
also example below):
Prog + , ⎺Mon: change setting
Enter, ◄, ►: move cursor to the left or to the right
Fig. 7-25: Enter parameter
• After desired parameter has been entered:
Press Enter key.
• Press Esc key.
• Press key ►.
Value of parameter is displayed.
• Press Esc key.
To display name and unit of parameter:
• Press key ▼.
Name and unit of parameter are displayed.
• Press ◄ key to go to previous display.
Example:
Last parameter displayed was S-0-0383.
Parameter P-0-1222 is to be displayed.
• S → key Prog + → P → key Enter
• 0 → key Enter
• → 0 key Prog + 1 → key ► →
• → 3 key → ⎺Mon → 2 ► key
• 8 → key ⎺Mon → 7 … → key ⎺Mon → 2 → key ►
• → 3 key → ⎺Mon → 2 ► key
• Press Enter key.
• Press Esc key.
• ► Press key.
Value of parameter P-0-1222 is displayed.
• Press Esc key.
DOK-INDRV*-FU*********-IB01-EN-P