Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

Rexroth IndraDrive Commissioning and Parameterization 7-73
Function
Function
Function
DOK-INDRV*-FU*********-IB01-EN-P
Note: Analog output 5 is only available in conjunction with a doubleaxis
device with configuration of 2 optional cards MA1!
See also Functional Description "Analog Outputs"
P-0-0417, Analog Output 6
Input min/max: Default value: Unit:
MPB: -10,000 / 10,000 0,000 V
This parameter displays the voltage value that is output via the analog
output 6 of the drive controller.
Note: Analog output 6 is only available in conjunction with a doubleaxis
device with configuration of 2 optional cards MA1!
See also Functional Description "Analog Outputs"
P-0-0418, Analog output, assignment A, signal value at
0V
Input min/max: Default value: Unit:
MPB: --- / --- 0 --
In this parameter the reference of the analog output of assignment A
(value with an output of 0 V) is defined. The unit is determined by the
parameter assigned in P-0-0420, Analog output, assignment A, signal
selection.
When assigning parameters with the "binary" display attribute, the
parameter is not active.
See also Functional Description "Analog Outputs"
P-0-0419, Analog output, assignment B, signal value at
0V
Input min/max: Default value: Unit:
MPB: --- / --- 0 --
In this parameter the reference of the analog output of assignment B
(value with an output of 0 V) is defined. The unit is determined by the
parameter assigned in P-0-0423, Analog output, assignment B, signal
selection.
When assigning parameters with the "binary" display attribute, the
parameter is not active.
See also Functional Description "Analog Outputs"
P-0-0420, Analog output, assignment A, signal selection
Input min/max: Default value: Unit:
MPB: --- / --- --- --