Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

Rexroth IndraDrive Index 10-9
DOK-INDRV*-FU*********-IB01-EN-P
operating conditions 4-7
operating hours 7-22
Operating hours control section 7-61
Operating hours power section 7-61
operating mode 7-4, 7-5
operating modes
basics 1-3
positioning block mode 7-137
Oscillation damping factor 7-82
overall structure of control loop (illustration) 7-132
Overload warning 7-75
Overview of device addresses 7-99
P
packaging
materials 8-37
Parallel input 1 7-57
Parallel output 1 7-57
parameter handling, general 1-1, 7-1
parameter management 7-31
parameter selection 7-30
parameter set
copy 7-32
parameterization 7-1, 7-12, 7-24
parameterization mode 7-4, 7-5
parameters 7-1
definitions of terms 1-1, 7-1
load 7-32
save 7-32
Parameters 1-1
performance data 1-10
Phase current U, actual value 7-56
Phase current V, actual value 7-56
positioning block mode 7-137
Positive velocity limit value 7-37
power reduction 4-8
power section
type current and type power 5-1
power sections
dimensions 6-1
Power supply status word 7-87
Power supply, configuration 7-59
power voltage
supply 5-3
power voltage supply 5-3
Premagnetization factor 7-78
Primary mode of operation 7-36
products
materials 8-37
profile types
freely configurable mode 7-116
I/O mode (positioning and preset velocity) 7-115
putting into operation
after fatal error has occurred (F8xxx errors) 8-4
after interface error has occurred (F4xxx errors) 8-3
after non-fatal error has occurred (F2xxx errors) 8-3
after travel range error has occurred (F6xxx errors) 8-3
nach after fatal system error has occurred (F9xxx or E-xxxx errors) 8-5
R
radio interference suppression
general measures 6-34
Ramp 1 pitch 7-91
Ramp 2 pitch 7-91
Rated motor speed 7-100
Recycling 8-37
reinforced barking resistors HLR01.1
dimensions 6-14