Rexroth IndraDrive C Drive Controllers HCS02.1 ... - Bosch Rexroth

Rexroth IndraDrive Mounting and Installation 6-43
Tightening Torque
Design
DOK-INDRV*-FU*********-IB01-EN-P
HCS03.1E- Cross section
single-wire
[mm²]
Cross section
multi-wire
[mm²]
Cross section
in AWG
W0070 16 - 6
W0100 35 - 2
W0150 50 2*25 0
W0210 95 2*50 4/0
Fig. 6-47: Connection cross section
HCS02.1E- Tightening torque [Nm]
W0012, W0028 0,5 – 0,6
W0054, W0070 1,2 – 1,5
Fig. 6-48: Tightening torques
HCS03.1E- Tightening torque [Nm]
W0070 1,5
W0100, W0150 6
W0210
Fig. 6-49: Tightening torques
25
CAUTION
Damage to the drive controller
Strain relief for the motor power cable must be
⇒
provided within the control cabinet, or you can use
the optionally available connection accessory
HAS02.1.
Note: Observe the following for use within the scope of C-UL:
• Use 60/75 °C copper wire only
• Use Class 1 wire only or equivalent
• Suitable for use on a circuit capable of delivering not more
than 8 kA (10 kA) rms symmetrical amperes for a
maximum voltage of 500 V (400 V)
X5, Motor Connection
DANGER
High electrical voltage! Danger to life, severe
bodily harm by electric shock!
Always operate the drive controller with plugged on
⇒
connector!
HCS02.1E- Type No. of
poles
W0012..0070 Screw terminal
block
Fig. 6-50: Design
Type of design
4 Pins on device