TranSystems Corporation - LGM Construction

501070099 Federal Express Oakland Sort Expansion Issued for Bid 10/11
specifications and not shown on the drawings, or shown on the drawings and not mentioned in the
specifications, shall be provided by the Contractor as if shown or mentioned in both.
B. Generally, the specifications describe work which cannot be readily indicated on the drawings and
indicate types, qualities and methods of installation of the various materials and equipment required for
the Work. It is not intended to mention every item of work in the specifications which can be adequately
shown on the drawings or to show on the drawings all items of work described or required by the
specifications even if they are of such nature that they could have been shown thereon. Materials or
labor for work which are shown on the drawings or are reasonably inferable there from as being
necessary to produce a finished job shall be provided by the Contractor whether or not the work is
expressly covered in the specifications.
C. The Contractor is responsible for the coordination of the various parts of the Work so that no part shall be
left in an unfinished or incomplete condition owing to any disagreement between the various
subcontractors, or the subcontractors and the Contractor, as to where the work of one begins and ends
with relation to the work of the other.
D. The Contractor and Subcontractors shall review other sections of work applicable to their work and
ascertain requirements in other sections applicable to their own work. Each shall be held responsible for
coordination and inclusion of the work indicated as if it were in the particular subcontractor's section. The
Owner shall be advised of any discrepancies or conflicts within seven days before the work commences.
E. All subcontractors, suppliers, etc., shall be responsible for knowing what information is given on all sheets
of the plans and specifications concerning his particular work. If an item or piece of work is shown on the
architectural and not on the mechanical, electrical, or structural drawings, it shall be included in the
contract. The reverse conditions shall also apply.
1.5 SPECIFICATION FORMAT
A. The specifications are separated into titled sections for convenience only and not to dictate or determine
the trade or craft involved. Such separation shall not operate to make the Owner, Construction Manager
or the Architect /Engineer an arbiter for the Division of responsibility between subcontractors.
END OF SECTION 01015
CONTRACT DOCUMENTS 01015 - 3