TranSystems Corporation - LGM Construction

501070099 Federal Express Oakland Sort Expansion Issued for Bid 10/11
SECTION 16132 - SECURITY SYSTEMS INFRASTRUCTURE
PART 1 - GENERAL
The Requirements of Section 16010 shall apply to this Section except as herein modified.
1.1 SCOPE
A. This Section describes the electrical work for the security systems infrastructure.
1.2 RELATED WORK
A. All equipment and wiring for the security systems will be supplied and installed by the
Owner or other Divisions, unless noted otherwise.
PART 2 - PRODUCTS
2.1 SECURITY SYSTEM OUTLET BOXES AND CONDUIT SYSTEM
A. Outlet boxes for security equipment shall be 2-1/2” deep and located as noted on the
drawings.
B. Cover all security system outlet boxes with blank cover plates. Cover plates shall be the
same as specified for receptacles in Section 16130, only with a blank cover.
C. For each security system outlet box shown or noted on the drawings, supply and install a
¾” conduit extended up to above the ceiling in finished areas or to the roof steel in non-
Sort unfinished areas, or to a wall location at the perimeter of the Sort equipment area that
is accessible by man-lift equipment if the outlet box is located in a Sort equipment area.
Install an insulated bushing on each conduit. Install a pull cord into each conduit, as per
Section 16130, to facilitate future cable installation.
PART 3 - EXECUTION
3.2 CLEANING
A. All equipment shall be thoroughly cleaned and left free of dust, dirt, grease, fingerprints,
and accumulated debris. Equipment shall be touched up where scratched with matching
paint.
END OF SECTION 16132
SECURITY SYSTEMS INFRASTRUCTURE 16132.1