TranSystems Corporation - LGM Construction

501070099 Federal Express Oakland Sort Expansion Issued for Bid 10/11
D. Install each door hardware item to comply with manufacturer's written instructions. Where cutting and
fitting are required to install door hardware onto or into surfaces that are later to be painted or finished in
another way, coordinate removal, storage, and reinstallation of surface protective trim units with finishing
work specified in Division 9 Sections. Do not install surface-mounted items until finishes have been
completed on substrates involved.
E. Thresholds: Set thresholds for exterior and acoustical doors in full bed of sealant complying with
requirements specified in Division 7 Section "Joint Sealants."
F. Adjustment: Adjust and check each operating item of door hardware and each door to ensure proper
operation or function of every unit. Replace units that cannot be adjusted to operate as intended. Adjust
door control devices to compensate for final operation of heating and ventilating equipment and to comply
with referenced accessibility requirements.
1. Spring Hinges: Adjust to achieve positive latching when door is allowed to close freely from an
open position of 30 degrees.
2. Door Closers: Unless otherwise required by authorities having jurisdiction, adjust sweep period so
that, from an open position of 70 degrees, the door will take at least 3 seconds to move to a point 3
inches (75 mm) from the latch, measured to the leading edge of the door.
3.2 DOOR HARDWARE SETS
Door Hardware Set No. 01 Non-CBP Exterior Storefront Entrance Door (Pair)
Manufacturer No./ ANSI /
Item
Description
BHMA No. Grade Finish
Hinges: 6 pair Full Mortise, Nonremovable Pins, BHMA A5111 1 Manufacture’s
41/2”x4 1/2"
standard
Lockset Concealed Vertical Rod Touch Bar
Panic per Storefront manufacturer
BHMA A156.3 1 Match Storefront
Operating Trim Storefront Manufacture’s standard 1 Match Storefront
Closer Storefront Manufacture’s standard 1 Match Storefront
Weather Stripping Head and Jamb Type, Two Piece BHMA R0Y104 Manufacture’s
Interlocking,
standard
Sill Sweep Storefront Manufacture’s standard 1 Manufacture’s
standard
Door Stop Floor Dome Type BHMA L02141 1 Black Anodized
Threshold Saddle type with thermal barrier BHMA J32190 1 Match Storefront
Door Hardware Set No. 02 Non-CBP and CBP Exterior Exit / Egress Door
Manufacturer No./ ANSI /
Item
Description
BHMA No. Grade Finish
Hinges: 3 pair Full Mortise, Nonremovable Pins,
41/2”x4 1/2"
BHMA A5111 1 Dull Stainless Steel
Lockset Fully Mortised Lock, Exit Device Von Duprin, 9975 1 Dark Bronze
Operating Trim Lever – Night Latch 9975L-NL 1 Dark Bronze
Closing Devices Parallel Arm Mounting Type BHMA C02021 1 Oil Rubbed Bronze
Rain Drip Applied to Frame Header Face BHMA R0Y936 Oil Rubbed Bronze
DOOR HARDWARE 08710 - 11