TranSystems Corporation - LGM Construction

501070099 Federal Express Oakland Sort Expansion Issued for Bid 10/11
D. Proposed substitutions which, upon evaluation by the Engineer, are not approved by the
Engineer shall not be permitted.
1.9 PENETRATION OPENINGS IN THERMAL INSULATION SYSTEMS
A. Penetration openings will be required by other Divisions in the thermal insulation systems
installed by this Division.
B. It is the responsibility of the specific Section within the Division requiring a penetration to:
1) locate and cut all such openings, 2) furnish and install all materials required to complete
the penetration with the exception of the materials to fill the void left in the thermal
insulation system and the materials for resealing the penetration, and 3) coordinate and
review all penetrations and procedures with this Division.
C. It is the responsibility of this Division to furnish and install all materials to fill the void in the
thermal insulation system installed by this Division and to properly reseal and re-establish
the watertight or vapor barrier continuity of the thermal insulation system.
1.10 REFERENCE STANDARDS
A. Portions or all of certain recognized industry or association standards referred to herein
shall be a requirement of these specifications and shall be considered as binding as
though herein reproduced in full. Unless otherwise stated, the reference standard shall be
the current standard as of the date of issuance of these specifications. Reference may be
made to standards either by full name or by abbreviation. The reference standards shall
include, but are not limited to, the following:
1.11 WORKMANSHIP
1. ASHRAE - American Society of Heating, Refrigeration and Air Conditioning
2. ASTM - American Society for Testing and Materials
3. UL - Underwriters' Laboratories, Inc.
4. FM - Factory Mutual
A. All work shall be installed in a first-class, neat and workmanlike manner only by mechanics
skilled in the particular trade and licensed as may be required.
1.12 RECORD DRAWINGS
A. The Contractor shall keep two sets of Contract Documents; i.e., drawings (including the
Owner insuring agency approved drawings), specifications, addenda, modifications, and
submittals at the site in good order, and annotated daily to show all changes made during
the construction process. At the conclusion of the project, the Contractor shall verify the
GENERAL PROVISIONS - LOW TEMPERATURE INSULATION 13010-4