TranSystems Corporation - LGM Construction

501070099 Federal Express Oakland Sort Expansion Issued for Bid 10/11
E. Installation of drain lines from evaporative coils, properly insulated, shall be included in
this contact.
F. Sleeves for refrigeration lines, drain lines and electrical lines shall be of extruded vinyl,
E.C. shall furnish and install seal-off fixtures in conduit for each light fixture to prevent
moisture from collecting in fixture. Coil supports to be provided in reinforced ceiling panels
to hang cooling coils. Mounting nuts and bolts which extend through the ceiling of walk-in
shall be of stainless steel.
G. Condensate and drain lines shall be extended nearest existing floor drain. All lines shall
be hard copper, using sweat fittings for all bends and turns. Lines for freezer coils shall be
wrapped with a thermostatically controlled heater tape or factory installed integral heater.
Cover drain liens with insulation required.
3.2 TESTING, START-UP AND INSTRUCTIONS
A. General: Delay start-up of free-standing freezer/cooler until services lines have been
tested, balanced and adjusted for pressure, voltage and similar considerations.
B. Test each item of operational equipment to demonstrate that it is operating properly and
that controls and safety devices are functioning. Repair or replace equipment that s found
to be defective in its operating, including units which are below capacity or operating with
excessive noise or vibration.
C. Instruct owner’s operating personnel in proper operation and maintenance procedures for
each item of operation equipment.
D. Final cleaning: After testing and start-up and before the time of substantial completion,
clean and sanitize equipment and heave in condition ready for use.
END OF SECTION 13100
WALK-IN COOLERS AND FREEZER 13100-9