GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Networker Software
gateway = 0. 0. 0. 0
#
# Port 1..4
# Directn in, out, off Set to off when used as aux.
# Start 1..512) Specifies range within the 512
# End 1..512 ) DMX channels.
# NetSlot 1..18432 Start network DMX slot.
# Priority blank, 1..3 Up to 3 priorities can be specified
# per channel, the highest priority
# active channel will be used.
# HTP blank, htp Set to htp to HighestTakesPrecedence
# up to 3 active priority channels
#
# A channel is 'active' if it has been seen on the network within
# the past 30 seconds.
# Multiple DMX = lines are used to set up multiple priorities or to
# configure sub ranges of DMX channels.
# DMX = Port Directn Start End NetSlot Priority HTP
DMX = 1 out 1 512 1
DMX = 2 out 1 512 1
DMX = 3 out 1 512 1025
DMX = 4 out 1 512 1537
#
# Configuration end
SN10X Node Self Test Software
SN10X nodes are supplied with comprehensive built-in test software which verifies correct operation at
power up. If a fault should be detected a message will appear on the VGA1 monitor and the Fader
LEDs will flash. Contact your dealer or Strand service department for more information.
Service engineers can access the built in diagnostics as follows, using a PC keyboard and the supplied
adapter :-
1. Press Ctrl-X to exit from the application and return to DOS.
2. Restart the application in test mode by typing 220os /TEST in the c:\220os directory and follow
the on-screen prompts.
3. The optional command line switches /MASTER and /SLAVE can be used with the /TEST switch
to perform back-to-back Ethernet tests with two SN10X Nodes.
file:///C|/LIGHTP/HELP.ENG/page15.htm (9 of 23)11/2/2004 3:02:29 AM