GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Networker Software
for 252 units on this subnet.
The format of the Internet address is:- AAA.BBB.CCC.DDD
where AAA,BBB,CCC and DDD are decimal number between 0 and 255. with the subnet mask shown
and the default Internet address, suitable Internet addresses can be formed as follows:-
192.168.000.XXX where XXX cannot be 0, or 255.
In a system that contains 5 SN10X’s (for example) a suitable Internet configuration would be :-
Node Internet address
SN100 (a) 192.168.000.70
SN100 (b) 192.168.00.71
SN100 (c) 192.168.00.72
SN100 (d) 192.168.000.73
SN100 (e) 192.168.00.74
DMX data input and output is controlled by the use of the DMX keyword. The DMX keyword has the
following syntax,
DMX = Port Type Start End Slot
where,
Port is either 1, 2, 3 or 4.
Type specifies whether the Port is IN, OUT or OFF.
IN specifies that DMX data coming in on the specified Port should be placed on the network at
the specified global network slot, the first and last dimmers sent out from the incoming DMX
frame are specified by the START and END numbers. The START and END numbers must be
between 1 and 512.
OUT specifies that DMX data coming in on the network at the specified global network channel
offset, will be sent out of the DMX Port specified. The first and last dimmers sent out for the
outgoing DMX frame are specified by the START and END numbers.
OFF Specifies that this port is not being used for DMX
Field Name Description
my_nodeaddr IP of this device
my_nodetype Type of device - see comment for list.
my_nodename
Name of this device - 8 characters
maximum
netmask Net mask - for advanced use - use default.
file:///C|/LIGHTP/HELP.ENG/page15.htm (7 of 23)11/2/2004 3:02:29 AM