GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Profiles
You can create fade profiles for up, down and attribute fades by selecting one of the two X
Playbacks, selecting a profile number and pressing the {LEARN} softkey on the Profile LCD
Menu, followed by [*]. Running the next cue by pressing
[GO X1] or [GO X2] or moving the appropriate X Playback fader off zero will start the profile
learn process.
Note: A profile ‘learned’ in this way is not permanently assigned to the cue. It is only used
once, when the [GO X1] or
[GO X2] key is pressed.
Movement of the X Playback fader, including the Up and Down Fade Time and all movements
of the fader when not on zero or 100% are used to calculate the fade profiles.
Note: During learning, the Status Window will show PROFILE LEARN in flashing white text on
a red background. The Playback LCD on 500 Series consoles will show the profile numbers
being learned and the VGA title bar in the Profile Screen will show PROFILE PP LEARNING.
[PB] [PROFILE] [5] [PB] [1] {LEARN} [*] Learns intensity and attribute profiles on X Playback
1 (All Modes) . Where 5 is the Upfade profile and attribute fade, and 5 + 1 is the Downfade
profile.
[PB] {PROFILE] [6] [/] [7] [PB] [2] {LEARN} [*] Learns intensity profiles on X Playback 2 (All
Modes). Where 6 is the Upfade profile, 7 is the Downfade and the attribute fade is not affected.
Note: If Playbacks field in the Show Setup Screen is set to Single, or Split Single and Playback
2 is selected. An error message is generated.
[PB] {PROFILE] [/] [3] [PB] [1] {LEARN} [*] Learns intensity profile on X Playback 1 (All
Modes). Where 3 is the Downfade profile and the Upfade and attribute profiles are unaffected.
Viewing and Editing Learned Profiles.
When you have created the profile(s), you can view and edit them in the Profile Display using
End Editing only, as previously described.
Stopping the Learn Process
You can stop an active learn on either playback as shown:
file:///C|/LIGHTP/HELP.ENG/page26.htm (8 of 9)11/2/2004 3:03:08 AM