GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Archive Screen
3. Use the Wheel to select a printer type compatible with the printer connected to your
system. If you are not sure which printer type will work best, try printing few cues with
each printer setting.
4. If you are printing a show, select the parts of the show to print from the Archive
Selection window, or select Whole Show. Use the Trackball, or mouse, to move the red
highlight and [+] or [-] to select or clear the parts to load. Type the desired numbers in
the FIRST, LAST, and NUMBER FROM fields.
5. Select the channels you want to print. You can select a range of channels in use and a
range of channels not in use that you want to print. Channels in use are channels that
are used in any cue, group, effect, or submaster, not just channels in cues, and includes
intensity and attribute channels.
6. Select the printing options you want. Press {PRINT SHOW}, {DIMMER LOG}, {STATUS
LOG} or {NOTES} to start printing.
7. To cancel printing while it is in progress, press {STOP}. To go back to the LCD Archive
menu press {BACK}.
While the console is printing, a Print Operation % Complete message shows printing progress
from 0% to 100%.
{PRINT SHOW} prints all of the items you checked in the Archive Selection window. Printing
options available for this print mode are:
Print Channels Includes channel levels for each item.
Add Attributes lets you print channel attributes as well as intensities.
Level Changes Only prints only items with changes in them.
1 Item per Page makes sure that each new item printed starts at the top of a page. Leaving
this off conserves paper if you are printing the whole show.
New Line at Channel Break (otherwise | ) puts the start of each new channel range (after some
channels were skipped) on a new line. This is normally off, and an upright bar is used to
indicate skipped channels.
Landscape (otherwise Portrait) lets you change the direction of printing on the page. It is
normally off, in which case all printing is in portrait orientation.
Clear Operations
Pressing [ARCHIVE] {CLR} displays the Archive Selection window in the State screen and the
LCD Clear menu. This lets you clear all or part of the show.
Note: You cannot undo a clear operation. If the show needs to be used again, make sure that
it is saved onto local disk or floppy disk before clearing it. For information on how to save refer
file:///C|/LIGHTP/HELP.ENG/page27.htm (18 of 19)11/2/2004 3:03:02 AM