GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Effects
Changes effect 1 up fade time to 4 seconds and its down fade time to 2 seconds without
changing any levels.
[FX] [1] [TIME] [/] [2] [*] All Modes
Changes effect 1 down fade time to 2 seconds without changing any levels. Sets the up
fade time to the time in the Setup display FX|Up/ field if this is a new effect or leaves it as
is if over-recording.
F[FX] [1] [TIME] [4] [/] [*] All Modes
Changes effect 1 up fade time to 4 seconds without changing any levels. Sets the down
fade time to the time in the Setup display FX|/Down field if this is a new effect or leaves it
as is if over-recording.
Assigning Profiles to Effects
fx# [PROFILE] # [*] assigns a fade profile to the effect. Since no levels are changed, you get no
rerecord warning with this command. To learn how to create and edit profiles refer to Profiles To delete
an assigned fade profile, omit the fade profile number.
[FX] [1] [PROFILE] [3] [*] All Modes
Assigns fade profile 3 to effect 1.
[FX] [1] [PROFILE] [*] All Modes
Deletes any fade profile assigned to effect 1.
Creating Effect Steps
To add a new effect step to the current effect, press {APPEND FXSTEP} when in the Effect display.
This adds a new step to the current effect and puts the cursor on the newly created step. The new step
has default values for step time, in, dwell, and out times, attribute fade time, low and high settings, and
scaling. It has no assigned levels.
Viewing Step Channel Levels
To view the recorded levels in a step:
If the cursor is in the Effect Settings window, press {EDIT STEPS} to put it on the first effect step
number in the FX Step window.
If the cursor is in the FX Step window but not on the effect step number, use the Trackball to highlight
file:///C|/LIGHTP/HELP.ENG/page35.htm (32 of 34)11/2/2004 3:03:13 AM