GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Patches
●
●
●
●
●
●
●
Patching Channel Intensities
Patching Double Width Outputs
Assigning Output Profiles
Patching Channel Attributes
Patching Non-Dims
Patching DMX In
Unpatching
Output Properties
Outputs have the following editable properties, which can be specified when patching or edited
later.
●
●
●
Output Type
Output Profile
Scaling Value
Types
Each output can be set to one of several types.
Unpatched No channel number. The output is not patched to any channel and so its
output is always 0. (see Unpatching)
Intensity The channel number is white (or yellow if it is not a one-to-one patch) and the
output is grey in Channel Order. In Output order, the Output is white and the channel
number is grey (or yellow if it is not a one-to-one patch. . The intensity output is patched
to a channel intensity. The output has a Scaling Factor (shown in grey below the
channel number) which modifies the basic channel level and can range from 0% to
200%. A value of 100% has no effect, a value of 0% disables the output (its value is
always 0). For example with a level of 80% on the Live display, scaling of 50% would
cause an output of 40%. Scaling values over 100% cause the output to reach its full
intensity faster than other outputs. For instance, if the scaling is 150% the output will be
at 75% when the channel it is patched to is still at 50%. When the channel is at 67% the
output reaches full intensity. Its intensity will not increase as the channel intensity
increases above 67% If no scaling factor is set, the default scaling factor is assumed.
file:///C|/LIGHTP/HELP.ENG/page9.htm (2 of 21)11/2/2004 3:03:09 AM