GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels
[@] [-] [0] [.] [1] Direct 1 Digit
[@] [-] [0] [1] Direct 2 Digit
[@] [-] [0] [1] [*] Command Line
The existing current selection is unchanged but their levels are decreased by 1%
chans {UP%} selects the listed channels and increases their intensity levels by the percentage
set in the Up/Down % field in the User Setup Screen Control Modes window. The default is
5%, and will be used in examples. To set levels for the current selection, omit chans.
[1] {UP%} Command Line
Makes channel 1 the current selection and increases its level by 5%. For example, a channel
at 55% would go to 60%. Any levels over 100% are limited at 100%. {UP%} appears on the
LCD Live menu.
chans {DOWN%} selects the listed channels and decreases their intensity levels by the
percentage set in the Up/Down % field in the User Setup Screen Control Modes window. The
default is 5%, and will be used in examples. To set levels for the current selection, omit chans.
[1] {DOWN%} Command Line
Makes channel 1 the current selection and decreases its level by 5%. For example, a channel
at 55% would go to 50%. Any levels under 0% are limited at 0%. {DOWN%} appears on the
LCD Live menu.
chan {FULL} or chan [@] {FULL} [*] selects the listed channels and sets their intensity levels
to Full (100%). To set the current selection to Full, omit chans.
[1] {FULL} All Modes
[1] [@] {FULL} Direct 2 Digit
[1] [@] {FULL} [*] Command Line
Makes channel 1 the current selection and sets its level to Full. The [1] {FULL} syntax only
works in the Live display.
{FULL} The existing current selection is unchanged but their levels are set to Full. {FULL}
appears on the LCD Live menu. This only works in the Live display
chans [ON] or chans [@] [ON] [*] selects the listed channels and sets their intensity levels to
the on level. The on level is set by the On Level % field in the User Setup Screen (initially
100%) or the ON Level group (group 993.1). The ON Level group takes precedence over the
ON Level % field. For further information, refer to Groups. To set levels for the current
selection to the on level, omit chans.
[1] [ON] All Modes
[1] [@] [ON] Direct 2 Digit
[1] [@] [ON] [*] Command Line
Makes channel 1 the current selection and sets its level to the on level.[ON] The existing
current selection is unchanged but their levels are set to the on level.
file:///C|/LIGHTP/HELP.ENG/page5.htm (10 of 13)11/2/2004 3:02:44 AM