GeniusPro/Lightpalette Operator's Manual - Strand Lighting

PC Software
rename the shortcut to as required. You can now run the software by double-clicking on
the shortcut icon.
14. If you used a different name in step 6, locate the shortcut gp_95 or lp_95 and use the
right mouse button and select Properties. Select the 'Program' tab and change the
'Cmd Line' and 'Working Directory' to match the alternative location.
15. Alternatively, you can run the Offline Editor software by double clicking on the geniusp.
exe or lightp.exe files in the geniusp or lightp directory, or alternative location.
16. Close the Offline Editor and return to the desktop to instal the Helpfile, press Ctrl F12,
followed by F2 three times.
17. Instal the Help file, as described under Installing the Help file under Windows 9X
18. Double click on the shortcut or the geniusp.bat/lightp.bat to run the Offline Editor
software
19. Refer to the Keyboard Map or to the template at the back of the Operator Guide to
simulate the console keys using the PC keyboard.
Installing the Backup PC Kit
PC Software is supplied with a 100 channel application disk and a Networker Application disk.
You must register these disks with Strand’s Software Registration Centre and load the
password with the dongle connected. The dongle is then programmed with the password
facilities. If the dongle is disconnected, the PC software becomes the OffLine Editor, with
maximum channels and other facilities but no Networker.
Installing the Ethernet Card (PC Software only)
Install the supplied Ethernet card in your desktop PC following the instructions supplied with
the card. This procedure should only be carried out by qualified personnel. If in doubt please
refer to your dealer/supplier or Strand Service to arrange installation by qualified personnel.
Configuring the Ethernet Card (PC Software only)
For PC Software configure the Ethernet card as :-
Parameter Settings Note
file:///C|/LIGHTP/HELP.ENG/page48.htm (5 of 17)11/2/2004 3:02:54 AM