GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Front
is set to full also.
- Default number of frames is now 0 when patching attributes greater than .2(colour), when patching .2
the setup default is still used. This allows the attribute name to be displayed on the patch screen &
makes the setup item now purely a default colour frame.
- @ COPYFROM now copies preset group information rather than the level information
chan @ COPYFROM chan @ FULL * New syntax to copy level information (ie how the old @
copyfrom worked)
- Channel control wheeling in preview as set in User Setup:
OFF (wheel) & SHIFT+(wheel) scroll only
ON (wheel) masters channels, SHIFT+(wheel) scrolls
SHIFT+WHEEL (wheel) scrolls, SHIFT+(wheel) masters channels
- Channel range update fully supports presets & attribure filters
chans UPDATE CUE cue [THRU cue] FROM TEXT floor TEXT @ TEXT ceiling TEXT @ATT Position
*
chans UPDATE CUE cue [THRU cue] FROM GROUP grpA @ grpB @ATT Colour Position *
- Set channels in one preset group to another preset group
chans FROM TEXT floor TEXT @ TEXT ceiling TEXT @ATT Position *
chans FROM [@] GROUP grpA @ grpB @ATT Colour Position *
NB FROM key is not directly avaliable so to record into empty USER key:
MACRO_DISPLAY CUE USER FROM MACRO MACRO
- DOWN% & UP% added to Cue/Sub/Group preview lcd menus
This has meant RENUM & FROM are no longer avaliable from cue preview, as such:
FROM cueno RENUM * Use CUE 0 FROM cueno RENUM *
RENUM RENUM Use CUE 0 THRU 999.9 RENUM *
The old syntaxs still work in case they are in macros.
- Renumbering cues no longer loses preset group information.
- Automod improvements:
- now supports Attribute filters eg
chan AUTOMOD_FROM chan @ATT Position *
chan AUTOMOD_FROM chan @ lev @ATT Position *
chan AUTOMOD_FROM chan @ATT Position @ lev *
- now can use to swap channels eg
chanA AUTOMOD_FROM chanB *
chanB AUTOMOD_FROM chanA *
- attributes correctly automod & don't do "apply only if source > dest val"
- automodding individual attributes no longer sets whole destination channel as used
- automodding of presets now works & copies over the preset group information. If an @ level is
specified then the level is used.
chanA AUTOMOD_FROM chanB * Copy over preset info
chanA AUTOMOD_FROM chanB @ FULL * Copy over level info
- To help avoid an accidental level changes in preview pressing * on an empty command line no longer
selects all channels. This now only works on Output.
- SHIFT LOADx1 (on an empty command line) reloads the cue in X playback 1 thereby removing any
modifications done whilst in playback preview. Likewise SHIFT LOADx2 reloads the cue in X playback
2. (SHIFT LOADx1 used to be LOADx2)
- Current cue number & text shown on prompt line of output display.
- Attribute fade colours are now correct on output
file:///C|/LIGHTP/HELP.ENG/page0.htm (9 of 13)11/2/2004 3:02:19 AM