GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Automod
[8] {A-MOD FROM} [3] [@] [8] [*] Sets channel 3 to be replaced by channel 8 at
80% of its current level on an htp basis (Direct 1 Digit Mode}
Note: For Direct 2 Digit mode, 80% must be entered as 80.
[8] {A-MOD FROM} [3] [THRU] [5] [*] Sets channels 3 to 5 to be replaced by
channel 8 (All Modes)
[6] [THRU] [8] {A-MOD FROM} [5] [*] Sets channel 5 to be replaced by channels
6 to 8 (All Modes)
Note: When a fixture is paired in automod, all associated attribute channels are
automatically paired. You can also Automod individual intensity or attribute
channels using the decimal notation, (e.g., [3] [.] [1] {A-MOD FROM} [6] [.] [1]
[*]).
You can Automod a channel to itself. This would provide the opportunity to apply a scaling
factor to the channel
[6] {A-MOD FROM} [6] [+] [3] [*] Sets the intensity of channel 6 up 30% Note:
For Direct 2 Digit mode, 30% must be entered as 30.
When you have set up the Automod pairing, press {A-MOD ON}. A warning will appear (white
on a magenta box) USING AUTOMOD while Automod is active. To reset the channels to
normal operation, press {A-MOD OFF} to cancel Automod and clear the warning box.
Customising the Auto-Mod Screen
The Automod Screen can order the display in Destination order (default) or Source order.
Press the {SOURCE ORDER} softkey to display the paired channels in source order. Press
the {DEST ORDER} softkey to return the display to destination order.
Note: where more than one destination channel is paired to a source channel and the display
is in destination order, duplicate destination channels are shown in black. Similarly, if more
than one source channel is paired to a destination channel and the display is in source order,
the duplicate source channels are shown in black.
file:///C|/LIGHTP/HELP.ENG/page53.htm (2 of 4)11/2/2004 3:03:13 AM