GeniusPro/Lightpalette Operator's Manual - Strand Lighting

User Setup
# A number from 1 to 100 (default 50) giving maximum to minimum brightness.
Goosneck Bright (not available on 300 Series Consoles)
Sets the brightness of the console gooseneck lights.
# A number from 1 to 100 (default 100) giving maximum to minimum brightness
Buzzer Volume
Enables or disables the buzzer which is used to signal errors. Its value is OFF or ON (default).
Macro Tablet
Sets the optional macro tablet to OFF (default), INTUOS A4, INTUOS A4 OS or INTUOS A3.
Setting this field to INTUOS A4, INTUOS A4 OS or INTUOS A3 enables the use of the A4, A4
Oversize or A3 macro tablet to activate preset macros.If set to INTUOS A4, INTUOS A4 OS
or INTUOS A3, the Port, must be set OFF, COM1 or COM2. NET NODE identifies the nework
node to which the Macro tablet is connected an may be Local (default) or the network node
name.The A4, A$ Oversize or A3 macro graphic tablet software can be used only when the
CommuniquéPro software is installed. (For further information, refer to Macro Tablet
The Mode option provides the facility to set up the macro grid on an A4, A4 Oversize or A3
Macro Tablet as shown below:
Macro Tablet Mode Grid
INTUOS A4 MACRO (LOW) 20 x 10
INTUOS A4 MACRO (MED) 20 x 20
INTUOS A4 MACRO (HIGH) 40 x 20
INTUOS A4 OS MACRO (LOW) 20 x 16
INTUOS A4 OS MACRO (MED) 20 x 32
INTUOS A4 OS MACRO (HIGH) 40 x 32
INTUOS A3 MACRO (LOW) 20 x 20
INTUOS A3 MACRO (MED) 20 x 40
INTUOS A3 MACRO (HIGH) 40 x 40
file:///C|/LIGHTP/HELP.ENG/page18.htm (20 of 21)11/2/2004 3:02:40 AM