GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Console Reporter
Learns load on specified rack number
{LEARN LOAD} [DIMMER] [#] [#] [#] [#] [*] [*]
Learns load on specified dimmer number
{LEARN LOAD} [DIMMER} {AT CHAN} [#] [#] [#] [#] [*] [*]
Learns load at specified channel number.
{LEARN LOAD} [DIMMER] {AT CHAN} [#] [#] [#] [#} [*] [*]
Learns loads on all dimmers on the specified channel number.
{RACK} Allows selection of Rack, as above.
{OUTPUT FILT} Displays Output Filter screen
{BACK} Returns to previous menu
Output Filter Display
You can filter out particular fault conditions, such that Reporter will ignore the filtered fault for the
output specified. By default, all dimme faults are reported.
You can filter out fault reporting using the [DIMMER] key to display the Dimmer Softkey Menu and the
{FILTER} softkey to display the Dimmer Filter Softkey Menu. Using the softkeys as part of a command,
enables you to filter out specific fault conditions for an output or range of outputs. The following filter
softkeys are available:
{HIGH DC} {OVERLOAD} {OVERHEAT} {OUTPUT ERROR} {LOAD LIMIT} {TRIP}
The following shows examples of the filter function:
[DIMMER] [6] {FILTER} {OUTPUT ERROR} [*]
Filter out any output fault reports for output 6 (All Modes)
[DIMMER] [1] [THRU] [5] {FILTER} {HIGH DC} {OVERHEAT [*]
Filters out any high DC fault and overheat reports for outputs 1 to 5 (All Modes).
[DIMMER] [6] [SHIFT] {FILTER} [*]
Inhibits all reporting for output 6 (All Modes)
[DIMMER] [6] {FILTER} [*]
Removes all filters from output 6 (All Modes)
file:///C|/LIGHTP/HELP.ENG/page11.htm (6 of 8)11/2/2004 3:03:05 AM