GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Key, Wheel VDU Remapping
Remapping VGA Screens
You can remap a console to view VGA screen outputs other than its own. This is an essential
function where a console’s control surface has been remapped to create a virtual remote
console. In this case, the user must be able to view the functions carried out by the virtual
remote console as well as the main console’s functions.
It may also be desireable to view the functions carried out by a remote console connected to a
network (refer to Network Video).
The maximum number of screens per console is four (fitted with Quad Video Card). The
following example shows a 550 main console with two screen where the second screen has to
be remapped to show the functions of VGA1 from a remote 520 console (Console 2) on VGA2.
Map Configuration File Command line
VGA Screen Console to View Screen to View
500_VGA2, 2, 1,
e.g., 500_VGA2, 2, 1,
The following example shows a 4-screen 550 main console whose control surface has been
remapped to create a virtual console within the same console. The virtual console is referred to
as remote 1. Two of the four screens require to be remapped to show the functions of the
virtual remote.
file:///C|/LIGHTP/HELP.ENG/page13.htm (9 of 10)11/2/2004 3:03:15 AM