GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Working with Channel Levels
[1] [REMDIM] All Modes
Makes channel 1 the current selection and sets all other channels to 0%.
[REM DIM] [REM DIM] All Modes
If a current selection exists, its channels are unchanged and all others are set to 0%. If
there is no current selection, all channels are set to 0% after a second press of the key.
This is a very useful way to achieve a blackout.
Fading in Intensity Channels in Time
You can set a channel selection to reach the set levels over a period of time using the [TIME]
key as shown.
[1] [THRU] [3] [TIME] [5] [@] [5] Set channels 1 to 3 inclusive from current level to 50% over
a period of 5 seconds. (Direct Action Modes). Time must be specified as 2-digit for Direct 2
Digit Mode.
[1] [THU] [3] [@] [5] [TIME] [5] [*] Set channels 1 to 3 inclusive from current level to 50% over
a period of 5 seconds. (Command Line Mode).
Fading In Attribute Channel Levels in Time
You can fade in attribute channel levels in the same way as for intensity channels.
[1] [.] [3] [TIME] [5] [@] [5] Moves the channel 1 luminair pan to position 5 over a period of 5
seconds. (Direct Digit Modes)
[1] [.] [3] [@] [5] [TIME] [5] [*] Moves the channel 1 luminair pan to position 5 over a period of
5 seconds. (Command Line Mode)
Top of
Page
file:///C|/LIGHTP/HELP.ENG/page5.htm (12 of 13)11/2/2004 3:02:44 AM