GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Basic Recording
Note: When recording cues on 300 Series and 520 consoles the [REC MODE] key is used to
display the Cue Type options and the {INTS ONLY} and {ATTS ONLY} softkeys on the LCD
display. To record cues with {INTS ONLY} or {ATTS ONLY} when using a 520 or 300 Series
console, you must therefore include the [REC MODE] key in the command as follows:
[CUE] [1] [REC MODE] {INTS ONLY} [RECORD] Direct 1 Digit and
Direct 2 Digit (520 and 300 Consoles only)
[RECORD] [CUE] [1] [REC MODE] {INTS ONLY}[*] Command Line
(520 and 300 Consoles only)
Records cue 1 with intensity levels and erases attribute levels.
Recording Without Submasters and Effects
If you are in the Live display, you can use type # to record the console output levels minus any
levels being provided by submasters and effects. This command does not work from any of the
preview displays.
[SUB] [1] [REC SUB] All Modes
Records submaster 1 without submasters and effects.
Note: For 300 consoles,use [SHIFT] [RECORD] in place of [REC SUB].
[SHIFT] [RECORD] is the same as [REC SUB] on 500 series consoles.
Recording Specific Channels
You can specify the channels you want to record in a cue, group, effect step, or submaster.
This is done by prefixing any of the commands above with the channel selection to record. The
[+], [-], [THRU], and {THRU ON} are used to select the channels to record.
chan [SUB] [2] records the currently selected channels into the submaster without
changing any other recorded levels.
[1] [SUB] [2] [RECORD] Direct 1 Digit and Direct 2 Digit
[1] [RECORD] [SUB] [2] [*] Command Line
Records channel 1 levels into submaster 2 without changing any other recorded levels.
[1] [+] [3] [THRU] [5] [SUB] [2] [RECORD] Direct 1 Digit and Direct 2 Digit
[1] [+] [3] [THRU] [5] [REC SUB] [SUB] [2] [*] Command Line
Records channels 1, 3, 4, and 5 levels into submaster 2 without effects and submasters,
file:///C|/LIGHTP/HELP.ENG/page25.htm (3 of 9)11/2/2004 3:02:48 AM