GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Recording Cues
Records levels into cue 1 and assigns up and down delay
times of 4 seconds.
[CUE] [1] [DELAY] [4] [/] [2] [*] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [DELAY] [4] [/] [2] [*] Command Line
Records levels into cue 1 and assigns an up delay time of 4
seconds and a down delay time of 2 seconds.
[CUE] [1] [DELAY] [/] [2] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [DELAY] [/] [2] [*] Command Line
Records levels into cue 1 and assigns a 2 second delay for down fades. Sets the delay
time for the up fade to the default time, or leaves it as is if over-recording
[CUE] [1] [DELAY] [4] [/] [RECORD] Direct 1 and 2 Digit
[RECORD] [CUE] [1] [DELAY] [4] [/] [*] Command Line
Records levels into cue 1 and assigns a 4 second delay for up fades. Sets the delay
time for the down fade to the default time, or leaves it as is if over-recording.
cue [DELAY] # [*] changes the delay time of the specified cue without changing
recorded levels. You do not get an overrecord warning with this command if the cue
exists.
If the specified cue doesn’t exist, creates a new cue with no levels but with the
specified delay times. If you only enter one number for time, it is used for both the
up and down delay times. To enter separate up and down delay times, use [/] to
separate the two numbers. The first number becomes the up delay time and the
second number becomes the down delay time.
[CUE] [1] [DELAY] [*] All Modes
Resets cue 1 delay time to the non-split default delay time in the User Setup
Screen Cue Delay Up/Down field.
[CUE] [1] [DELAY] [4] [*] All Modes
Changes cue 1 up and down delay times to 4 seconds without changing any
levels.
[CUE] [1] [DELAY] [4] [/] [2] [*] All Modes
Changes cue 1 up delay time to 4 seconds and its down delay time to 2 seconds
without changing any levels.
[CUE] [1] [DELAY] [/] [2] [*] All Modes
Changes cue 1 down delay time to 2 seconds without changing any levels. The
up delay time is set to the time in the User Setup Screen Cue Delay Up field if this
is a new cue or left as it is if over-recording.
[CUE] [1] [DELAY] [4] [/] [*] All Modes
Changes cue 1 up delay time to 4 seconds without changing any levels. The
file:///C|/LIGHTP/HELP.ENG/page45.htm (6 of 22)11/2/2004 3:02:32 AM