GeniusPro/Lightpalette Operator's Manual - Strand Lighting

CommuniquéPro
1. Use the trackball to move to the Function field of the Submaster to change.
2. Use the wheel or the [+] or [-] keys to change it to DMX DIMR or DMX CHAN.
The Submaster window of the LIVE screen indicates DMX In Submasters by a C (DMX
Channel) or D (DMX Dimmer). No channel levels need be entered for DMX IN Submasters.
Patching DMX In Dimmers
To patch DMX IN Dimmers go to the PATCH screen by pressing the [PATCH] screen key.
DMX IN Dimmers are identified on the display by a trailing D (e.g. 1D, 2D, 50D) and are
displayed in magenta.
To change the default use one of the following commands:
sel [@] [+] # [*]
This patches the output to the DMX Input Channel. The default Scaling is used if this is not
currently patched to a DMX Input Channel otherwise it is left unchanged.
[1] [THRU] [1] [0] [@] [+] [5] [THRU] [1] [4] [*]
Patches output 1 to 10 to DMX Input Channel 5 to 14, scaling unchanged.
sel [@] [+] # [@] [*]
This patches the output to the DMX Input Channel; default Scaling is always used, as defined
in Setup.
[1] [@] [+] [5] [@] [*]
Patches output 1 to DMX Input Channel 5 with default scaling.
sel [@] [+] # [@] # [*]
This patches the output to the DMX Input Channel with the specified Scaling.
[1] [@] [+] [5] [@[7] [5] [*]
Patches output 1 to DMX Input Channel 5 with 75% scaling.
sel [@] [@] # [*]
The existing patch is unchanged but the DMX Input Channel is used with the specified Scaling.
[1] [@] [@] [7] [5] [*]
Patch is unchanged but is set to DMX Input with 75% Scaling.
file:///C|/LIGHTP/HELP.ENG/page8.htm (4 of 22)11/2/2004 3:02:24 AM