GeniusPro/Lightpalette Operator's Manual - Strand Lighting

Effects
If you leave out fx#, the current effect is assumed.
If you leave out pb# and the specified effect is not loaded, the next available playback is used. If you
don’t include pb# and the specified effect is loaded, the effect playback on which it is loaded is
assumed. If you don’t include pb# and multiple copies of the effect are loaded, the lowest numbered
effect playback on which the effect is running is assumed.
Note: Since these examples are only part of a command, they do not have concluding [*] key.
The [+], [-], [THRU], {THRU ON}, [LAST], and [NEXT] keys cannot be used in an effect playback
selection.
The examples shown immediately below are effect playback selections that you can use to replace fx
where it appears in full command descriptions.
Note: To load and run an effect on a 300 Series console, press [FX] # [FX GO]. This will load the
effect on the next available effect playback and start the effect running. To load an effect without
running the effect, you can simulate the [FX LOAD] key using the ACII key command (Alt 4)
[FX] # [FX LOAD] (Direct 1 and Direct 2 Digit)
[FX LOAD] [FX] # [*] (Command Line)
Specifies the effect number to load on the next available effect playback. If the effect is
already loaded, it reloads it onto the same playback. If the effect is loaded on multiple
playbacks, it reloads it onto the lowest numbered of these playbacks. If the effect does
not exist or all playbacks are loaded, the command is ignored.
[FX] [1] [FX LOAD] (Direct 1 and Direct 2 Digit)
[FX LOAD] [FX] [1] [*] (Command Line)
If effect 1 is already loaded, selects that Playback. Otherwise, selects the first unloaded
playback (if any) and loads it with effect 1 (if recorded).
[FX] # [PB] # [FX LOAD] (Direct 1 and Direct 2 Digit)
[FX LOAD] [FX] # [PB] #[*] (Command Line)
Specifies an effect and a playback to load. If the effect does not exist, the command is
ignored.
[FX] [1] [PB] [2] [FX LOAD] (Direct 1 and Direct 2 Digit)
[FX LOAD] [FX] [1] [PB] [2] [*] (Command Line)
If effect 1 is already loaded on Playback 2, selects it. Otherwise selects Playback 2 and
loads it with effect 1 (if recorded).
[FX] [PB] # [FX LOAD] (Direct 1 and Direct 2 Digit)
file:///C|/LIGHTP/HELP.ENG/page35.htm (19 of 34)11/2/2004 3:03:13 AM