GeniusPro/Lightpalette Operator's Manual - Strand Lighting

PC Software
5 500 Series
B Backup PC
O Offline Editor
F File Server
3. Press B to install the Backup PC Software
4. Specify either GeniusPro or Lightpalette installation by typing g or i. This should match
the console software type.
5. You will be prompted to enter a destination path for the Backup PC software. By default,
the software will be installed in C:\geniusp or C:\lightp. Enter a destination directory
name of 8 characters or less, or accept the default destination by pressing .
6. You will be prompted to enter a destination path for the show files. By default, the show
files will be stored in C:\shows. Enter a destination path, or accept the default location by
pressing .
7. The Strand Lighting licence agreement is displayed on screen. Press any key to scroll
the display.
8. If you agree with the terms of the licence, press Y, or press N to terminate the
installation.
9. The Networker software will install on your PC.
10. If the installation was successful, 'Instal Successful' is displayed on screen.
11. Press Ctrl F12, followed by F2 three times to return to DOS
12. Proceed to install the Help file as described under Installing Help under DOS 3.1 or later
If the DOS installation fails, try disabling SHARE or SMARTDRV lines in the PC's AUTOEXEC.
BAT file. You can enable them again after installation.
WARNING: You should disable Norton Commander because it can cause hard disk corruption
when running operating software on a PC.
Installing the Networker & Utilities Software from Windows 9X
1. Insert the Networker &Utilities disk in the floppy drive
2. Open the A: drive window and double click on the installation icon, as follows
C5INSTAL for non i 400 or 500 Series consoles, or
CIINSTAL for 500i Series consoles, or
C3INSTAL for 300 Series consoles)
3. You will be given a choice of platform, e.g.,
3 300 Series
4 400 Series
5 500 Series
B Backup PC
file:///C|/LIGHTP/HELP.ENG/page48.htm (9 of 17)11/2/2004 3:02:54 AM